Siemens Sinumerik 810T User Manual page 104

3 Operating Sequences
3.1.4 Tool offset
2
L1 Geometry
3
L2 Geometry
4
Diameter/radius
Geometry values of the available
tool types:
The input of tool geometry values can be inhibited with
5
L1 Wear
6
L2 Wear
7
Diameter/radius
The input of tool wear data can be inhibited by means
3-6
Under points P = "2" and P = "3", you enter
the geometry values of the turning tools into
the input field
Under point P = "4" you enter the value of the
cutter radius.
1. Turning tool
Facing tool
L1
L2
a key switch.
Under points P = "5" to P = "7", you can (not
obligatory) enter the wear data of the tools into
the input form.
The machine tool manufacturer can set the
maximum wear input to ± 0.999 mm.
of a key switch!
© Siemens AG 1990 All Rights Reserved
01.93
2. Grooving tool
(left tip)
L1
L2
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)