Siemens Sinumerik 810T User Manual page 198

09.91
DRY
YES-NO
Display:
All blocks in which a feedrate is programmed (G01, G02, G03, G33, G34, G35) will now be
traversed at the feedrate value entered into the "Dry run feedrate" setting data, instead of
the programmed feedrate.
The dry run feedrate then applies to "Feed per revolution" G95, and the feedrates for
threading (G33,G34,G35).
OPT.
STOP
YES-NO
Display:
When an "M01" is present in the part program, the program is stopped.
When the softkey function is marked with "NO", "M01" is ignored.
OVERR.
YES-NO
Display:
This signal requires that there is a common feedrate/rapid override switch. If the softkey
function is set to "NO", this override switch is only active with "feedrate". If the softkey
function is set to "YES", the override set with this override switch is also effective for rapid
traverse.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810T, GA3 (BN)
You select, for example, the "DRY RUN FEEDRATE" softkey.
Dry run feedrate
You select, for example, the "OPTIONAL STOP" softkey function
Optional stop
You select, for example, the "RAPID OVERRIDE" softkey
function.
Rapid override
6ZB5 410-0EP02
3 Operating Sequences
3.2.3 Influencing "AUTOMATIC" operation
YES
YES
YES
3-95