Interrupting The Program - Siemens Sinumerik 810T User Manual

3 Operating Sequences
3.2.3 Influencing "AUTOMATIC" operation

3.2.3.4 Interrupting the program

Sequence of operation
You can interrupt a running program in one of the following ways:
1) Perform one of the operating mode changes which causes a reset (see Section
2.3.4). The drives are brought to a controlled standstill.
2) By NC STOP:
The axis positions programmed in the current block are
3-104
Operate the "NC STOP" key.
The feed drives are brought to a controlled standstill
without leaving the programmed path.
The "STOP: AUTO INTERRUPTED" display appears.
Now operate the "NC Start" and "Feed start" keys.
The feed is enabled again.
approached with linear interpolation.
Caution: danger of collision!!
© Siemens AG 1990 All Rights Reserved
01.93
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)