Siemens Sinumerik 810T User Manual page 50

2 Operation
2.1.2 SINUMERIK 810T operator interface with external machine control panel
Function of the direction keys
+X
With this key you traverse the "X" axis.
– X
With this key you traverse the "X" axis in the opposite direction.
+Z
With this key you traverse the "Z" axis.
– Z
With this key you traverse the "Z" axis in the opposite direction.
+Q
With this key you traverse the "Q" axis (Auxiliary axis).
– Q
With this key you traverse the "Q" axis in the opposite direction.
Rapid traverse override:
When you operate this key at the same time as any of the keys above, the
axis is traversed at rapid.
The "rapid traverse" rate is defined in machine data .
Two cover plates next to each other
2-32
Modules for additional special func-
tions can be installed instead of these
cover plates.
© Siemens AG 1990 All Rights Reserved
11.90
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)