Table of Contents
Advertisement
11.90
Feed or rapid traverse override decrease / increase
The two keys make it possible for you to decrease or increase the
programmed feedrate value "F" (with reference to 100% value).
The value set with these keys is displayed as an absolute value and
as a percentage.
Operate the
The feedrate is decreased in the following steps:
– by 5%, in the feed range
– by 10%, in the feed range
– by 2%, in the feed range
– by 1%, in the feed range
Continuous operation causes the feedrate to be decremented in
steps until the end value 0% (standstill) is reached.
Operate the
The feedrate is increased in the following steps:
– by 1%, in the feed range
– by 2%, in the feed range
– by 10%, in the feed range
– by 5%, in the feed range
Continuous operation causes the feedrate to be incremented in
steps until the end value 120% is reached.
The increments specified apply to standard machine
Socket connector for universal interface
Beneath the cover hinged on the left, you will find a 25-pole socket
1
14
o
o
o
for D-type sub-miniature connectors.
o
o
o
o
o
o
o
o
Via this V.24 (RS232) / 20 mA interface, you can transfer serial data
o
o
o
to or from peripheral devices.
o
o
o
o
o
o
o
o
o
o
o
25
13
For details of transmission data see Section 6.3 (Setting data), and for device connection see
Section 6.4 (Device connection data).
For details of the correct cables see: "SINUMERIK System 800", Configuring Instructions /
Universal Interface.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810T, GA3 (BN)
2.1.1 SINUMERIK 810T operator interface with integrated machine control panel
key quickly.
key quickly.
data.
6ZB5 410-0EP02
120 %
to 70 %
70 %
to 10 %
10 %
to
2 %
2 %
to
0 %
0 %
to
2 %
2 %
to 10 %
10 %
to 70 %
70 %
to 120 %
2 Operation
2-23
Hide quick links:
Advertisement
Table of Contents
