Data Input - Siemens Sinumerik 810T User Manual

3 Operating Sequences
3.1.15 Data input/data output

3.1.15.2 Data input

Sequence of operation
DATA
IN-OUT
(( 810T))
(( Bild 37 von Druckerei
einmontieren
1
F
or
2
D
DATA-IN
START
On the upper right-hand side of the CRT the message
displayed.
On the Data type: line the data coming from the transmission device (tape reader,
programmer ...) is identified.
The following table explains the types of data that can be loaded into the 810T:
3-80
Operate the "DATA IN-OUT" softkey in any of the
operation modes:
PRESET / JOG / AUTOMATIC /
INC 1 .... INC 10 000 / REFPOINT.
This input form is shown, with the input
field for "Interface for data in" marked
in inverse video.
Now enter:
"1" ( for input into interface 1 ) or
"2" ( for input into interface 2 )
and store it with the input key.
Select the softkey function "DATA-IN START"
By doing this you enable the control's receive function.
DIO
© Siemens AG 1990 All Rights Reserved
(Data input/output) is
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)
11.90