Deleting All Offset Values In An Offset Number D - Siemens Sinumerik 810T User Manual

3 Operating Sequences
3.1.4 Tool offset
3.1.4.3 Deleting all offset values in an
offset number D ...
a) You would like, for example, to delete all values stored under tool offset number "D5".
Sequence of operation
5
Using the key you enter "5".
J
You operate the "Delete word/block" key.
When you now select the tool offset number "D5", using either the "Page up/down"
keys , or by entering the number "5" and operating the search key
can check that all the values in this offset number have been set to "zero".
b) You would like, for example, to delete all stored values under tool offset numbers "D4" to
"D9".
Sequence of operation
4 = 9
L H Z
When you now call the tool offset numbers "D4" to "D9", as described in a) above, you can
check that all offset values have been set to "zero".
3-10
Using the keys you enter "4 = 9".
You operate the "Delete word/block" key.
© Siemens AG 1990 All Rights Reserved
11.90
, you
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)