Siemens Sinumerik 810T User Manual page 207

09.91
Sequence of operation
REPOS
and
or
The "REPOS offset" with reference to the endpoint of the preceding block appears on the
display.
+X +Q
– Z +Z
– Q – X
AUTO-
MATIC
or
Program processing continues after you have pressed the "NC start" key.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810T, GA3 (BN)
3.2.3 Influencing "AUTOMATIC" operation
Operate the operating mode selection key on
the integrated machine control panel, and then
the "REPOS" softkey or ...
... set the operating mode selector switch on
the external machine control panel to this
symbol.
Operate the relevant direction keys.
The control guides the tool using linear
interpolation to the endpoint of the preceding
block.
Now switch again into the "AUTOMATIC"
mode, using either the softkey or the
operating mode selector switch.
6ZB5 410-0EP02
3 Operating Sequences
3-103