Siemens Sinumerik 810T User Manual page 47

09.91
Reset
When you operate the "Reset" key:
• The current part program being processed is interrupted.
• Diagnostics messages are cleared
(Alarm nos. 100 . . . . 2999)
• The control is switched to the "Reset" state:
–
–
–
Program stop / program start (NC stop / NC start)
When you press the "Program stop" key:
The program being processed is interrupted. You can continue the
operation by pressing "Program start".
When you press the "Program start" key:
The part program called is re-started at the current block. In automatic
operation the overstored functions are transferred to the PLC.
Spindle stop / Spindle start
When you operate the "Spindle stop" key:
•
Examples of the use of "Spindle stop"
•
•
•
•
When you operate the "Spindle start" key:
•
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810T, GA3 (BN)
2.1.2 SINUMERIK 810T operator interface with external machine control panel
the NC remains synchronized with the machine
all buffer and working memories are cleared (the part program
memory remains unchanged)
the control is in the reset condition and ready for a new program
start.
the spindle is brought to a standstill.
during operation in "MDI AUTOMATIC" mode, a block with a fault is discovered
in "JOG", "INC..","REPOS" modes, e.g. during repositioning to the contour
to change a tool
to input S, T, H, M functions during setting up
(overstore).
the spindle speed accelerates to the value specified in the part
program.
6ZB5 410-0EP02
2 Operation
2-29