Display Panel - Siemens Sinumerik 810T User Manual

2 Operation
2.1.1 SINUMERIK 810T operator interface with integrated machine control panel

2.1.1.2 Display panel

?
View of the display panel
"Alarm" display
• The red LED lights up whenever there is a signal from the diagnostics
?
monitor. The CRT display shows you the relevant message no. and
the message text (2nd line of display).
• The message numbers are explained in the Alarm list in Section 4 of
this Operator's Guide.
?
• The LED is extinguished when the message has been acknowledged:
with acknowledge key
with RESET key
With certain messages, the display is only extinguished when the
cause of the fault has been cleared (Section 4).
"Out of position" display
• The green LED is bright when at least one axis is moving.
• The LED is extinguished when all axes have reached their command
positions.
If the display
permissible value. You must carry out drift compensation.
DIAGNOSIS
2-4
does not extinguish after traversing, the drift has exceeded the
Press the "DIAGNOSIS" softkey.
Extend the softkey menu with the ETC key at the right below
the screen.
© Siemens AG 1990 All Rights Reserved
Symbols
LED displays
(Section 2.1.1.5)
(Section 2.1.1.6 or 2.1.2.1).
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)
09.91