Table of Contents
Advertisement
6 Data Interfaces
6.4 Device connection data
Siemens Programmer
PG 685/675/670/730/750
Interface S5 PLC
Cable Order No.:
6FC9 340-8G
6FC9 344-4R
(PG 750/730 only)
Device data
Interface:
Transfer rate:
Character format:
Operating conditions
For PLC programming the PG 685/675/
670/750 programmer should be connected
directly to interface 1 (20 mA current loop
interface) on the SINUMERIK 810T.
(If cable 6FC9340-8G is used with the
PG 750, the supplied adaptor must be
used)
Siemens Programmer PG 675/685
Interface Printer
Cable Order No.: 6FC9 344-1A.
Device data
Interface:
Transfer rate:
Character format:
Operating conditions
Archiving of NC cycles and programs onto
disk, and the transfer to and from the NC
and the creation of programs is possible
with the PG 675/685.
For data transfer, the PG 675/685 should
be connected from the printer interface to
an RS232C (V.24) interface on the
SINUMERIK 810T.
6-6
Siemens programmer PG 615 U with
PG 615 adapter and power pack
Interface PLC
Cable Order No.: 6FC9 340-8H.
Device data
20 mA current
Interface:
loop
9600 baud
Transfer rate:
1 Start bit,
Character format:
7 Data bits,
1 Parity bit (even
parity),
2 Stop bits
Operating conditions
For PLC programming the PG 615 program-
mer is connected via the adapter and a cable
to interface 1 (20 mA current loop) on the
SINUMERIK 810T.
RS232C (V.24)
1200 baud
1 Start bit
8 Data bits
2 Stop bits
© Siemens AG 1990 All Rights Reserved
01.93
20 mA current
loop
9600 baud
1 Start bit
7 Data bits
1 Parity bit
(even parity)
2 Stop bits
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)
Hide quick links:
Advertisement
Table of Contents
