Adjusting The White Balance Manually - Sony DCR-TRV40 Operating Instructions Manual

Adjusting the white balance manually
You can manually adjust and set the white halance. This adjustment makes white
subjects look white and allows more natural color halance. Normally white halance is
automatically adjusted.
(1) Set the POWER switch to CAMERA or MEMORY/NETWORK (DCR-TRV50
only). Press MENU, then select WHT BAL in _ with tile SEL/PUSH EXEC
dial (p. 200).
(2) Turn the SEL/PUSH EXEC dial to select the desired white balance, then press
dial.
HOLD :
Recording a single colored subject or background
"_- OUTDOOR :
• When recording a stmset/stmrise, just after stmset, just betiore stmrise, neon
signs, or tileworks
• Under a color matching fluorescent lamp
_ INDOOR :
• Where lighting condition changes quickly
• Excessively bright places such as studios
• I Inder sodium lamps or mercury lamps
MENU
54
To return to the automatic white balance
Set WHT BAL to AUTO in the menu settings.
It the picture is being taken in a studio lit by IV lighting
We recommend that you record in the INDOOR.
When you record under fluorescent lighting
Use the automatic white halance or HOLD.
Your camcorder may not adjust the white balance correctly in the INDOOR.
In the automatic white balance
Point your eamcorder at a white subject fbr ahout 10 seconds after setting the POWER
switch to CAMERA to get a better adjustment when:
You detach the battery for replacement.
You take your camcorder outdoors from inside a house holding the exposure, or vice
versa.
In the HOLD white balance
Set the white balance to AUTO and reset to HOLD after a few seconds when:
You change the PROGRAM AE.
You take your camcorder outdoors fi'om inside a house, or vice versa.