Adjusting The White Balance Manually - Sony DCR-TRV19 Operating Instructions Manual

Adjusting the white balance manually

Normally white balance is automatically adjusted.
The POWER switch should be set to
TRV33 only).
Operate by touching the panel.
(1) Press FN to display PAGE1.
(2) Press MENU to display the menu.
(3) Select WHT BAL in
(4) Select a desired mode, then press EXEC.
HOLD:
When recording a single-colored subject or background
OUTDOOR (
•When recording a sunset/sunrise, just after sunset, just before sunrise, neon signs, or
fireworks
•Under a color matching fluorescent lamp
INDOOR (n) :
•When lighting conditions change quickly
•In too bright places such as photography studios
•Under sodium lamps or mercury lamps
To return to FN
Press EXIT.
To return to the automatic white balance
Set WHT BAL to AUTO in the menu settings.
If the picture is being taken in a studio lit by TV lighting
We recommend that you record in the INDOOR mode.
When you record under fluorescent lighting
Select AUTO or HOLD.
Your camcorder may not adjust the white balance correctly in the INDOOR mode.
If you did the followings in the AUTO mode
– You remove the battery pack for replacement.
– You bring your camcorder from indoors to outdoors holding the exposure, or vice
versa.
Point your camcorder at the white subject for about 10 seconds after setting the POWER
switch to CAMERA to get better adjustment.
If you did the followings in the HOLD mode
– You change the mode of PROGRAM AE.
– You bring your camcorder from indoors to outdoors, or vice versa.
Set WHT BAL to AUTO and reset to HOLD after few seconds.
52
, then press EXEC (p. 176).
MANUAL SET
PROGRAM AE
P EFFECT
FLASH MODE
FLASH LVL
WHT BAL
AUTO SHTR
):
or
EXIT
AUTO
HOLD
OUTDOOR
INDOOR
EXEC RET.
(DCR-TRV22/