Sony DCR-TRV40 Operating Instructions Manual page 99

Dubbing only desired scenes - Digital program editing (on tapes)
Make sure that your camcorder and VCR are connected, and that the VCR is set to
recording pause. When you use an i.LINK cable (DV connecting cable), this procedure
is not
necessary.
When you use a digital video camera recorder, set its power switch to VCR/VTR.
(1)
(2)
Turn the SEL/PUSH EXEC dial to select VIDEO EDIT in the menu settings,
then select TAPE, then press the diah
Turn the SEL/PUSH EXEC dial to select START, then select EXECUTE, then
press the dial.
Search fur the beginning of the first program, then start dubbing.
The program mark flashes.
The SEARCH indicator appears during search, and the EDITING indicator
appears during edit on the screen.
The program mark changes to light blue after dubbing ends.
When dubbing ends, your camcorder and the VCR autolnatically stop.
To stop dubbing during editing
Press • using the video operation buttons.
To end the Digital program editing
Your camcorder stops when the dubbing ends. Then the display returns to VIDEO
EDIT in the menu settings.
Press MENU to end the Digital program editing.
You cannot record on the VCR when:
The tape has rim out.
The write protect tab on the cassette is set to lock.
The IR SETUP code is not correct. (when IR is selected)
The button to cancel recording pause is not correct. (when IR is selected)
NOTREADYappears on the LCDscreen when:
The program to operate the Digital program editing has not been made.
i.LINK is selected but an i.LINK cable (DV connecting cable) is not connected.
The power of the connected VCR is not turned on. (when you set i.LINK)
¢Q
99