Sony DCR-TRV40 Operating Instructions Manual page 43

Playing back a tape
Date/time
_50min s_ 0:00:23:01
/2:0556 AM
JUL 4 2g02
Various settings
_40mi# s> 00023:01_ [a l
IF - _ [b]
[c] Ir d
[a] Tape counter
[b] SteadyShot OFF
[C] Exposure
mode
[d] White balance
[e] Gain
[f] Shutter speed
[g] Aperture
value
To not display various settings
Set DATA CODE to DATE in tile menu settings (p. 208).
The display changes as fffllows when you press DATA CODE oil the Remote
Conli_]ander:
date/time _+ no indicator
Various settings
Various settings are your camcorder's information when you have recorded. In the
recording, the various settings will not be displayed.
When you use the data code, bars (...... ) appear if:
A blank portion of the tape is being played back.
The tape is tmreadable due to tape damage or noise.
The tape was recorded by a camcorder without the date and time set.
Data code
When you connect your camcorder to the TV, the data code appears on the TV screen.
Remaining battery time indicator during playback
The indicator indicates the approximate continuous playback time. The indicator may
not be correct, depending on the conditions in which you are playing back. Wben you
close the LCD panel and open it again, it takes about one minute fur the correct
remaining battel T time to be displayed.
O"
_r
I
5
43