Configuring The Dsu/Csu For Telnet Access; Selecting The Port - Paradyne 3163 User Manual

ACCULINK 3163 DSU/CSU
Configuring the DSU/CSU for
Telnet Access
To configure the DSU/CSU for Telnet access,
Enable the Telnet server within the DSU/CSU (see
Appendix C, Configuration
Select and configure the port that provides the link
to the Telnet system.
Set the Internet Protocol (IP) address and subnet
mask needed to access the DSU/CSU (see
Appendix E, IP Network Addressing
Select the link layer protocol (PPP or SLIP) for the
port that provides the link to the Telnet system.
Specify the Telnet password, if desired (see
Appendix C, Configuration

Selecting the Port

The Telnet device or network device can be directly
connected to the communications (COM) port. An
external LAN Adapter can be connected to the COM port
to provide Ethernet or Token Ring connectivity. Use the
MODEM port when accessing the DSU/CSU through a
dial-up connection.
The COM port can support either synchronous or
asynchronous PPP, or asynchronous SLIP at data rates of
up to 38,400 bps. The MODEM port can support either
synchronous or asynchronous PPP, or asynchronous SLIP
at data rates of up to 2400 bps.
3-12
Options).
Scenarios).
Options).
March 1999
The example shown below assumes that the COM port
is being used as the link to the Telnet system.
"
Procedure
To select the COM port as the Telnet link:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the
User selection appears on the screen.
5. Select User.
Edit:
Chan
F1
6. Press F1 (Next) until the Com Use configuration
option appears.
7. Select Mgmt to configure the COM port as the
Telnet link.
Com Use:
Next
F1
key until the
Gen User
F2 F3
Mgmt ASCII
F2 F3
3163-A2-GB20-10