HP StorageWorks 9000 - Virtual Library System User Manual page 54

2. Locate the enclosure side brackets and the #8-32 x 3/16-inch flathead screws from the rack
mounting hardware kit contents.
NOTE:
The right and left side enclosure brackets are identical. Install the brackets with the beveled
slots facing away from the disk array enclosures.
a. Position the enclosure side bracket with the long edge down, and the arms flush with the
top of the enclosure.
b. Line up the outermost beveled slots of the enclosure side bracket with the rear holes in the
disk array enclosure. The rear arm extends slightly past the back of the enclosure.
c. Install two #8-32 x 3/16-inch flathead screws into the slots. Tighten both screws.
NOTE:
Using screws longer than #8-32 x 3/16-inch may result in interference with the power
supply.
d. Repeat this procedure for the other side bracket, and for each enclosure to be added.
54 Hardware Installation