Cabling Ethernet Switch 2810 24G; Ethernet Switch 2810 24G Port Cabling - HP StorageWorks 9000 - Virtual Library System User Manual

2. Connect one end of an Ethernet cable to port 16 of Ethernet Switch 2510 24. Connect the other
end of the Ethernet cable to RAID controller 1 on the base disk array enclosure of array 0.
3. Working backwards from port 16 on Ethernet Switch 2510 24, connect one end of an Ethernet
cable to the next available Ethernet port. Connect the other end of the Ethernet cable to RAID
controller 1 on the base disk array enclosure of array 1.
4. Repeat step 3 to connect all arrays.
NOTE:
Arrays 5 through 8, if present, reside in a separate rack.
5. Secure Ethernet cables with a Velcro tie to the right side of the rack.

Cabling Ethernet Switch 2810 24G

Figure 19 Ethernet Switch 2810 24G port cabling
.
Item
1
2—8
9—15
16
17
18
1. Connect one end of an Ethernet cable to the Ethernet port of Fibre Channel switch #2. Connect
the other end of the Ethernet cable to port 23 of Switch 2810 24G.
2. Connect one end of an Ethernet cable to port 16 of Ethernet Switch 2810 24G. Connect the
other end of the Ethernet cable to RAID controller 0 on the base disk array enclosure, of first
array (array 0).
3. Working backwards from port 16 on Ethernet Switch 2810 24G, connect one end of an Ethernet
cable to the next available Ethernet port. Connect the other end of the Ethernet cable to RAID
controller 0 on the base disk array enclosure, of the second array (array 1).
62 Hardware Installation
Description
Ethernet cable from NIC 2 of primary node
Ethernet cable from NIC 2 of secondary nodes (if present)
Ethernet cables from Ethernet ports of RAID controller 0 of base disk array enclosures of up
to 8 arrays (if present)
Ethernet cable from Ethernet port of RAID controller 0 of base disk array enclosure of 1st
array (array 0)
Ethernet cable from Fibre Channel switch #2
Ethernet cable from port 24 of Ethernet Switch 2510 24