Power Supply; Installing The Dvd-Cd Drive; Removing A Node Power Supply - HP StorageWorks 9000 - Virtual Library System User Manual

2. Slide the drive into the bay until it clicks.
Figure 76 Installing the DVD-CD drive
.

Power Supply

CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
1. Disconnect the power cord from the power supply.
2. Press the power supply release lever (1), and then pull the power supply from the node.
Figure 77 Removing a node power supply
.
To replace the component:
WARNING!
To reduce the risk of electric shock or damage to the equipment, do not connect the power cord to
the power supply until the power supply is installed.
1. Remove the protective cover from the connector pins on the power supply.
HP StorageWorks 259