Ethernet Switches; Usb Lan Adapter Replacement - HP StorageWorks 9000 - Virtual Library System User Manual

Hp storageworks 9000-series virtual library system user guide (ag306-96027, march 2010)
Hide thumbs Also See for StorageWorks 9000 - Virtual Library System:
Table of Contents

Advertisement

2.
Disconnect the Fibre Channel cable by squeezing the end of the cable connector.
If removing more than one cable, make sure that they are labeled before removing them. The
cables are fragile; use care when handling them.
CAUTION:
Mishandling Fibre Channel cables can degrade performance. Do not twist, fold, pinch, or
step on cables. Do not bend the cables tighter than a 2-inch radius.
3.
Some models of transceivers are held in place by a small wire bail actuator; pull down on the
top of the bail and rotate it in the downward direction.
4.
Grasp the transceiver between your thumb and index finger, and carefully remove it from the
Fibre Channel port.
5.
Insert a new transceiver in the Fibre Channel port and gently push in the transceiver until it clicks
in place.
NOTE:
A transceiver fits only one way in the port. If the transceiver does not install under gentle
pressure, pull it out of the port, turn it over, and re-insert it.
6.
Plug the Fibre Channel cable into the duplex jack at the end of the transceiver.
7.
Power on the system. See

Ethernet Switches

To replace the 100 Mb Ethernet Switch 2510 24 or the 1 Gb Ethernet Switch 2810 24G:
1.
Power off the switch.
2.
Make a note of all cable connections to the switch then disconnect the cables.
3.
From the front of the switch, loosen the captive thumbscrews until the thumbscrews are free of
the rack.
4.
Remove the switch from the rack.
5.
Install the new switch into the rack. See
Rack
or
Installing the 1 Gb Ethernet Switch 2810-24G into a
NOTE:
If you are replacing a 2824 with a 2810-24G, you will need to install new rails. The
2810-24G cannot use the 2824 rails.
6.
Reconnect all cables to the new switch exactly as they were connected to the failed switch.
7.
Power on the new switch.

USB LAN Adapter Replacement

To replace the USB LAN adapter:
Powering on the VLS9000 series
Installing the 100 Mb Ethernet Switch 2510-24 into a
System.
Rack.
HP StorageWorks
267

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vls 9000

Table of Contents