Cables; Regulatory Compliance Identification Numbers; Laser Device; Laser Safety Warning - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods
in order to maintain compliance with FCC Rules and Regulations.

Regulatory compliance identification numbers

For the purpose of regulatory compliance certifications and identification, your product has been
assigned a unique Regulatory Model Number. The RMN can be found on the product nameplate
label, along with all required approval markings and information. When requesting compliance
information for this product, always refer to this RMN. The Regulatory Model Number should not be
confused with the marketing name or model number of the product.

Laser device

All HP systems equipped with a laser device comply with safety standards, including IEC 825. With
specific regard to the laser, the equipment complies with laser product performance standards set by
government agencies as a Class 1 laser product. The product does not emit hazardous light.

Laser safety warning

WARNING!
To reduce the risk of exposure to hazardous radiation:
• Do not try to open the laser device enclosure. There are no user-serviceable components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser device other than
those specified herein.
• Allow only HP authorized service technicians to repair the laser device.

Laser product label

The optional label in
device.
Figure 58 Class 1 laser product label
.
This optional label indicates that the product is classified as a CLASS 1 LASER PRODUCT. This label
may appear on the laser device installed in your product.
174 Regulatory compliance and safety
Figure 58 or equivalent may be located on the surface of the HP supplied laser