HP StorageWorks 6100 - Enterprise Virtual Array User Manual page 101

The following is an example of the fciproute modify command:
mpx239 (admin) #> fciproute mod
Enter a new value or simply press the ENTER key to accept the
current value.
If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
WARNING: The following command might cause a loss of
connections to both GE ports.
Route FC Port ID GE Port ID
- — — — — — — — — — — — — —
1 FC1 GE1
2 FC2 GE2
Please select a FCIP route from the list above ('q' to quit):
2
Configuring FCIP Route: 2
- — — — — — — — — — — — — —
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
IP Address (IPv4 or IPv6; 0=IPv6 Link Local)
[2000:33::32:2:239]
IPv6 Default Router [::]
Remote IPv6 Address [2000:33::32:2:240]
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768]
Window Scaling (0=Enable, 1=Disable) [Enabled]
Window Scaling Factor (Min=0, Max=7) [7]
TCP Port No. (Min=1024, Max=65535) [3225]
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto]
Bandwidth, Mbit/sec (Min=1, Max=1000) [155]
VLAN (0=Enable, 1=Disable) [Disabled]
FCIP SW Compression (0=Enable, 1=Disable) [Disabled] 0
All attribute values for FCIP Route 2 will now be saved.
mpx239 (admin) #>
The following is an example of the fciproute remove command:
mpx110 (admin) #> fciproute rm
A list of attributes with formatting and current values will
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
WARNING: The following command might cause a loss of
connections to both GE ports.
Route FC Port ID GE Port ID
- — — — — — — — — — — — — —
1FC2 GE2
2FC1 GE1
Please select an FCIP route from the list above ('q' to quit):
1
FCIP Route 1 has been removed from the system.
IP Distance Gateway User Guide 101