Set System Command - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

Set System command

Configures general mpx110 parameters.
Authority
Syntax
Parameter
The following is an example of configuring an SNMP trap destination:
mpx239 (admin) #> set snmp trap_destinations
nl
nl
A list of attributes with formatting and current values will
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
nl
nl
Configuring SNMP Trap Destination 1 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled] 0
IP Address (IPv4 or IPv6)[0.0.0.0] 10.6.6.28
Destination Port [0]
Trap Version [0]
Configuring SNMP Trap Destination 2 :
—-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 3 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 4 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 5 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
nl
Configuring SNMP Trap Destination 6 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 7 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
Configuring SNMP Trap Destination 8 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ]
All attribute values that have been changed will now be
saved
mpx239 (admin) #>
Admin session
set system
port_num
Sets the number of the iSCSI port to be configured for iSNS
IP Distance Gateway User Guide 115