Set Snmp Command - HP StorageWorks 6100 - Enterprise Virtual Array User Manual
Hp storageworks ip distance gateway user guide (5697-0376, april 2010)
Hide thumbs
Also See for StorageWorks 6100 - Enterprise Virtual Array:
- User manual (462 pages) ,
- User manual (232 pages) ,
- User manual (362 pages)
Table of Contents
Advertisement
Set SNMP command
Configures general SNMP properties. It also provides for configuration of up to eight trap destinations.
Authority
Syntax
Parameter
Examples
114
Command-line interface
Admin session
set snmp
trap_destinations
Sets the number of the trap destinations to be configured for SNMP
The following is an example of the set snmp command:
mpx110 (admin) #> set snmp
nl
nl
A list of attributes with formatting and current values will
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
nl
Configuring SNMP:
-----------------
Read Community
Trap Community
[ ] Private
System Location
[ ]
System Contact
[ ]
Authentication Traps (0=Enable, 1=Disable) [Disabled]
All attribute values that have been changed will now be saved
[ ] Public
Advertisement
Table of Contents
