Show Fciproutes Command - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

Show FcipRoutes command

Shows FCIP route configuration parameters.
Authority
Syntax
Parameter
Example
118 Command-line interface
None
show fciproutes
[link_id]
Sets the number of the FCIP route to be displayed (1 or 2)
The following is an example of the show fciproutes command:
mpx239 (admin) #> show fciproutes
FCIP Route Information
------------------------ FCIP Route 1
FCIP Interfaces Status Enabled
FCIP Link Status Up
FC Port FC1
GE Port GE1
GE Link Status Up
Local IP Address 44.44.1.239
Remote IP Address 44.44.1.240
Subnet Mask 255.255.0.0
Gateway IP Address 0.0.0.0
MTU Size Normal
TCP Window Size 32768
Window Scaling Enabled
Window Scaling Factor 7
TCP Port No 3225
Current GE Port Speed 1Gb/FDX
Programmed GE Port Speed Auto
Bandwidth, Mbit/sec 155 VLAN Disabled FCIP SW
Compression Disabled
FCIP Route 2
FCIP Interfaces Status Enabled
FCIP Link Status Up
FC Port FC2
GE Port GE2
GE Link Status Up
IPv6 Address 1 2000:33::32:2:239
IPv6 Link Local fe80::2c0:ddff:fe0d:b27b
IPv6 Remote Address 2000:33::32:2:240 MTU Size Normal
TCP Window Size 32768
Window Scaling Enabled
Window Scaling Factor 7
TCP Port No 3225
Current GE Port Speed 1Gb/FDX
Programmed GE Port Speed Auto
Bandwidth, Mbit/sec 155
VLAN Disabled
FCIP SW Compression Disabled
mpx239 (admin) #>