Hp Storageworks Mpx Manager For Windows; Hp Storageworks Mpx Manager For Linux; Setting Mpx110 Management Port Parameters - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

Hp storageworks ip distance gateway user guide (5697-0376, april 2010)
Hide thumbs Also See for StorageWorks 6100 - Enterprise Virtual Array:
Table of Contents

Advertisement

HP StorageWorks mpx Manager for Windows

You can install HP StorageWorks mpx Manager on a Windows server. To install the HP StorageWorks
mpx Manager application from the HP StorageWorks IP Distance Gateway installation file:
1.
Close all programs currently running, and then unzip the executable file to the system.
2.
Double-click the executable to start the installation.

HP StorageWorks mpx Manager for Linux

This section describes how to install HP StorageWorks mpx Manager on a Linux server.
NOTE:
In the following procedure, replace n.n.nn and n.n.nnbnnn with a file name (for example, 2.0.30
and 2.0.30b112).
1.
Download the hpmpx_n.n.nn_linux_install.tar file from
storage/networking/index.html. The .tar file contains the .bin file and a GUI install README
file.
2.
Unpack the file to a temporary directory. For example:
tar -zxvf hpmpx_n.n.nn_linux_install.tar
3.
Enter the following to start the install:
./hpmpxn.n.nnbnn_linux_install.bin.
A chmod may be necessary prior to execution.
4.
Follow the installation instructions on the screen and note the installation location. The default
directory is /opt/Hewlett-Packard/mpxManager.

Setting mpx110 management port parameters

NOTE:
If you are using Telnet to configure the mpx110 for the first time, your workstation IP address must
be 10.0.0.x, where x is a number other than 1, and the subnet mask is 255.0.0.0.
To set the initial mpx110 configuration parameters:
1.
Connect the mpx110 management port to a workstation to configure the initial mpx110
parameters. You can connect the mpx110 management port to an IP switch or hub, directly to
the workstation with an Ethernet crossover cable to the management port, or to the RS-232 port
with a serial cable.
NOTE:
If connecting to the mpx110 serial port, the terminal settings are 115200 baud, 8 bit, 1
stop bit, no parity, and no flow control.
http://h18006.www1.hp.com/
IP Distance Gateway User Guide
43

Advertisement

Table of Contents
loading

Table of Contents