Set MGMT command
Configures the mpx110 management port (10/100).
Authority
Syntax
Example
112
Command-line interface
Admin session
set mgmt
The following is an example of the set mgmt command:
mpx239 (admin) #> set mgmt
A list of attributes with formatting and current values
will follow. Enter a new value or simply press the
ENTER key to accept the current value.
If you wish to terminate this process before reaching
the end of the list press 'q' or 'Q' and the ENTER key
to do so.
WARNING:
The following command might cause a loss of connections
to the MGMT port.
IPv4 Interface (0=Enable, 1=Disable) [Enabled]
IPv4 Mode (0=Static, 1=DHCP, 2=Bootp, 3=Rarp) [Static]
IPv4 Address [10.6.7.239]
IPv4 Subnet Mask [255.255.248.0]
IPv4 Gateway [10.6.4.200]
IPv6 Interface (0=Enable, 1=Disable) [Disabled] 0
IPv6 Mode (0=Manual, 1=AutoConfigure) [Manual]
IPv6 Address 1 [:: ] 2000:10::32:239:1
IPv6 Address 2 [:: ]
IPv6 Default Router [:: ]
All attribute values that have been changed will now be
saved.
mpx239 (admin) #>
98 Command-
All attribute values that have been changed will
now be saved.
mpx239 (admin) #>