Configuring FCIP routes
Follow these steps to configure the mpx tuning parameters and FCIP routes using the CLI or the mpx
Manager GUI.
Configuring mpx IP tuning parameters using the CLI or GUI
See
"IP performance
For each mpx110 FCIP route, configure the following tuning parameters:
•
Bandwidth setting
•
Software compression
•
TCP window size/scaling
NOTE:
The mpx110 integrates a software compression option. Enable compression for IP fabrics with an
RTT greater than or equal to 50 ms, or guaranteed WAN bandwidth of less than or equal to 45 Mb/s.
See
IP performance
NOTE:
With the exception of the tuning parameters listed above, HP strongly recommends that you use the
default mpx110 settings shown in
Configuring the FCIP routes using the CLI
For each mpx110, configure the FCIP route information as shown in
Figure 20 Setting FCIP route using the CLI
.
48
Installation and upgrades
tuning" on page 31 for information on the required configuration settings.
tuning" on page 31 for link speed and delay information.
Figure
20.
Figure
20.