Fcip Routes Add Wizard Tcip/Ip Options Dialog Box - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

8. Enter the TCP/IP parameters in the TCP/IP Options dialog box
Figure 51 FCIP Routes Add Wizard TCIP/IP Options dialog box
.
Use the TCP/IP Options dialog box to configure the following parameters:
• Jumbo Frames Provides a dialog box for enabling and disabling Jumbo IP frames. When
disabled, the MTU is 1,500 bytes; when enabled, the maximum MTU is 9,000 bytes. When
other is selected, the MTU size can be configured between 1,000 and 9,000 bytes.
• TCP Window Size Contains a dialog box that provides three options for TCP window size:
8,192, 16,384, and 32,768 bytes. The default is 32,768.
• Window Scaling Contains a dialog box that provides for enabling and disabling TCP window
scaling. The default is Disabled. When enabled, the Window Scaling Factor is used.
• Window Scaling Factor Contains a dialog box that provides eight options for TCP window
scaling: 0, 1, 2, 3, 4, 5, 6, and 7
• VLAN Enabled Provides a dialog box for enabling and disabling VLAN support. The default
is Disabled.
• VLAN ID Provides a dialog box that enables the user to define the VLAN ID (available only
when VLAN is enabled). The VLAN ID must be the same on both routers participating in the
FCIP route (local and remote routers must also be using the same VLAN ID) and the Ethernet
switches.
• VLAN Priority Provides a dialog box that contains eight options for the VLAN priority, 0
through 7. This dialog box is available only when VLAN is enabled.
9. After setting the TCP/IP parameters, click Next to continue or Cancel to exit the wizard.
(Figure 51).
IP Distance Gateway User Guide 85