HP StorageWorks 6100 - Enterprise Virtual Array User Manual page 100

Examples The following is an example of the fciproute add command:
mpx239 (admin) #> fciproute add
A list of attributes with formatting and current values will
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
WARNING: The following command might cause a loss of connections to
both GE ports.
Configuring FCIP Route: 1
— — — — — — — — — — — — — —
FCIP Interfaces FC & GE (0=Enable, 1=Disable)
FC Port (1=FC1, 2=FC2, ...)
GE Port (1=GE1, 2=GE2, ...)
IP Address (IPv4 or IPv6; 0=IPv6 Link Local)
44.44.1.239
Subnet Mask [0.0.0.0
Gateway IP Address [0.0.0.0 ]
Remote IP Address [0.0.0.0
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768]
Window Scaling (0=Enable, 1=Disable)[Disabled] 0
Window Scaling Factor (Min=0, Max=7) [0] 7
TCP Port No. (Min=1024, Max=65535) [3225]
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto]
Bandwidth, Mbit/sec (Min=1, Max=1000) [1000] 155
VLAN (0=Enable, 1=Disable) [Disabled]
FCIP SW Compression (0=Enable, 1=Disable) [Disabled]
VLAN (0=Enable, 1=Disable) [Disabled]
FCIP SW Compression (0=Enable, 1=Disable) [Disabled]
All attribute values for FCIP Route 1 will now be saved.
mpx239 (admin) #>
100 Command-line interface
[FC1]
[GE1]
] 255.255.0.0
] 44.44.1.240
[Enabled]
[0.0.0.0 ]