Setting The Switch Status Policy Threshold Values - HP SN3000B Administrator's Manual

Setting the switch status policy threshold values

1. Connect to the switch and log in using an account with admin permissions.
2. Enter the switchStatusPolicySet command.
3. Verify the threshold settings you have configured for each parameter.
Example output from a switch
The following example displays what is typically seen from a Brocade switch, but the quantity and
types vary by platform.
Fabric OS Administrator's Guide
53-1002446-01
WWN
CP
Blade
CoreBlade
Flash
MarginalPorts 0.00%[0]
FaultyPorts 0.00%[0]
MissingSFPs 0.00%[0]
ErrorPorts 0.00%[0]
Number of ports: 4
The current switch status policy parameter values are displayed. You are prompted to enter
values for each DOWN and MARGINAL threshold parameter.
NOTE
By setting the DOWN and MARGINAL values for a parameter to 0,0 that parameter is no longer
used in setting the overall status for the switch.
Enter the switchStatusPolicyShow command to view your current switch status policy
configuration.
switch:admin> switchstatuspolicyshow
To change the overall switch status policy parameters
The current overall switch status policy parameters:
Down
-----------------------------------
PowerSupplies
Temperatures
Fans
Flash
MarginalPorts 25.00%[12]
FaultyPorts 25.00%[12]
MissingSFPs
ErrorPorts
Number of ports: 48
Note that the value, 0, for a parameter, means that it is
NOT used in the calculation.
** In addition, if the range of settable values in the prompt is (0..0),
** the policy parameter is NOT applicable to the switch.
** Simply hit the Return key.
The minimum number of
Bad PowerSupplies contributing to DOWN status: (0..2) [2]
Track and control switch changes
0 0
0 0
0 0
0 0
0 0
0.00%[0]
0.00%[0]
0.00%[0]
0.00%[0]
Marginal
2 1
2 1
2 1
0 1
10.00%[5]
10.00%[5]
0.00%[0] 0.00%[0]
0.00%[0] 0.00%[0]
3
57