Viewing An Alias In The Defined Configuration; Zone Creation And Maintenance; Creating A Zone - HP SN3000B Administrator's Manual

Viewing an alias in the defined configuration

1. Connect to the switch and log in using an account with admin permissions.
2. Enter the aliShow command, using the following syntax
Example

Zone creation and maintenance

To create a broadcast zone, use the reserved name "broadcast". Do not give a regular zone the
name of "broadcast". See
special type of zone.
Virtual Fabrics considerations: Zone definitions should not include logical port numbers. Zoning is
not enforced on logical ports.

Creating a zone

1. Connect to the switch and log in using an account with admin permissions.
2. Enter the zoneCreate command, using the following syntax:
3. Enter the cfgSave command to save the change to the defined configuration.
Example
Fabric OS Administrator's Guide
53-1002446-01
alishow "pattern"[, mode]
If no parameters are specified, the entire zone database (both the defined and effective
configuration) is displayed.
The following example shows all zone aliases beginning with "arr".
switch:admin> alishow "arr*"
alias: array1 21:00:00:20:37:0c:76:8c
alias: array2 21:00:00:20:37:0c:66:23
"Broadcast zones"
zonecreate "zonename", "member[; member...]"
To create a broadcast zone, use the reserved name "broadcast".
The cfgSave command ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this command is run,
the transaction on the other switch is automatically aborted. A message displays on the other
switches to indicate that the transaction was aborted.
switch:admin> zonecreate "greenzone", "2,32; 2,33; 2,34; 4,4"
switch:admin> zonecreate "bluezone", "21:00:00:20:37:0c:66:23; 4,3"
switch:admin> zonecreate "broadcast", "1,2; 2,33; 2,34"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled. Until the Effective
configuration is re-enabled, merging new switches into the
fabric is not recommended and may cause unpredictable
results with the potential of mismatched Effective Zoning configurations.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y

Zone creation and maintenance

on page 244 for additional information about this
11
249