HP SN3000B Administrator's Manual page 526

Brocade fabric os administrator's guide - supporting fabric os v7.0.1 (53-1002446-01, march 2012)
Hide thumbs Also See for SN3000B:
Table of Contents

Advertisement

24
LSAN zone configuration
10. Enter the cfgAdd and cfgEnable commands to create and enable the LSAN configuration.
11. Log in as an admin and connect to the FC router.
12. Enter the following commands to display information about the LSANs:
On the FC router, the host and Target A are imported, because both are defined by
lsan_zone_fabric2 and lsan_zone_fabric75. However, Target B is defined by lsan_zone_fabric2
and is not imported because lsan_zone_fabric75 does not allow it.
When a PLOGI, PDISC, or ADISC arrives at the FC router, the SID and DID of the frame are checked.
If they are LSAN-zoned at both SID and DID edge fabrics, the frame is forwarded to the DID. If they
are not zoned, only the PLOGI is dropped; for the remaining frames zoning enforcement takes place
in the edge fabrics.
488
zone:
lsan_zone_fabric2
10:00:00:00:c9:2b:c9:0c; 50:05:07:61:00:5b:62:ed;
50:05:07:61:00:49:20:b4
Effective configuration:
no configuration in effect
switch:admin> cfgadd "zone_cfg", "lsan_zone_fabric2"
switch:admin> cfgenable "zone_cfg"
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
Do you want to enable 'zone_cfg' configuration
zone config "zone_cfg" is in effect
Updating flash ...
lsanZoneShow -s shows the LSAN.
switch:admin> lsanzoneshow -s
Fabric ID: 2 Zone Name: lsan_zone_fabric2
10:00:00:00:c9:2b:c9:0c
50:05:07:61:00:5b:62:ed
50:05:07:61:00:49:20:b4
Fabric ID: 75 Zone Name: lsan_zone_fabric75
10:00:00:00:c9:2b:c9:0c
50:05:07:61:00:5b:62:ed
fcrPhyDevShow shows the physical devices in the LSAN.
switch:admin> fcrphydevshow
Device
Exists
in Fabric
-----------------------------------------
75 10:00:00:00:c9:2b:c9:0c c70000
2
50:05:07:61:00:49:20:b4 0100ef
2
50:05:07:61:00:5b:62:ed 0100e8
Total devices displayed: 3
fcrProxyDevShow shows the proxy devices in the LSAN.
switch:admin> fcrproxydevshow
Proxy
WWN
Created
in Fabric
----------------------------------------------------------------------------
75
50:05:07:61:00:5b:62:ed
2
10:00:00:00:c9:2b:c9:0c
Total devices displayed: 2
(yes, y, no, n): [no] y
Imported
EXIST
EXIST
EXIST
Imported
WWN
Physical
PID
Proxy
Device
PID
Exists
in Fabric
01f001
2
02f000
75
Physical
State
PID
0100e8
Imported
c70000
Imported
Fabric OS Administrator's Guide
53-1002446-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os v7.0.1

Table of Contents