Disabling F_Port Trunking; Enabling The Dcc Policy On A Trunk Area - HP SN3000B Administrator's Manual

•

Disabling F_Port trunking

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the portDisable command to disable the ports that are to be removed from the trunk
3. Enter the portTrunkArea

Enabling the DCC policy on a trunk area

After you assign a trunk area, the portTrunkArea CLI checks whether there are any active DCC
policies on the port with the index TA, and then issues a warning to add all the device WWNs to the
existing DCC policy with index as TA.
All DCC policies that refer to an Index that no longer exists will not be in effect.
1. Add the WWN of all the devices to the DCC policy against the TA.
2. Enter the secPolicyActivate command to activate the DCC policy.
Fabric OS Administrator's Guide
53-1002446-01
Port Type State
-------------------------------------
36 F-port Master
37 F-port Slave
38 F-port Slave
39 F-port Slave
Enter the porttrunkarea --show trunk command to display the trunking information.
switch:admin> porttrunkarea --show trunk
Trunk Index 37: 39->0
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
38->1
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
37->1
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
36->1
Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%)
Rx: Bandwidth 16.00Gbps, Throughput 1.62Gbps (11.76%)
Tx+Rx: Bandwidth 32.00Gbps, Throughput 3.24Gbps (11.80%)
area.
This command does not unassign a TA if its previously assigned Area_ID is the same address
identifier (Area_ID) of the TA unless all the ports in the trunk group are specified to be
unassigned.
switch:admin> portdisable 0-2
switch:admin> porttrunkarea --disable 0-2
Trunk index 2 disabled for ports 0, 1, and 2.
You must enable the TA before issuing the secPolicyActivate command in order for security to
enforce the DCC policy on the trunk ports.
Master TI DI
36 37 36
36 37 37
36 37 38
36 37 39
sp: 8.000G bw: 16.000G deskew 15 MASTER
sp: 8.000G bw:
sp: 8.000G bw:
sp: 8.000G bw:
disable command to remove ports from the trunk area.
--
Disabling F_Port trunking
8.000G deskew 15
8.000G deskew 15
8.000G deskew 15
22
449