This section includes an FA-PWWN configuration procedure for each of the following two topologies:
•
•
These topologies are shown in
FIGURE 50
Configuring an FA-PWWN for an HBA connected to an Access Gateway
For this procedure, some of the steps are to be executed on the switch and some are to be
executed on the server.
1. Log in to the edge switch to which the Access Gateway is directly connected.
2. Assign the FA-PWWN.
3. Enter the following command:
Fabric OS Administrator's Guide
53-1002446-01
An FA-PWWN for an HBA device that is connected to an Access Gateway switch.
An FA-PWWN for an HBA device that is connected directly to an edge switch.
Access Gateway Switch
running FOS 7.0.0
F-Port
HBA
Scenario 1
An FA-PWWN is
configured for an HBA
device connected to an
Access Gateway Switch.
Fabric-assigned port world wide name provisioning scenarios
•
If you are manually assigning a WWN, enter the following command:
fapwwn --assign -ag AG_WWN -port AG_port -v Virtual_PWWN
•
If you want the WWN to be automatically assigned, enter the following command:
fapwwn --assign -ag AG_WWN -port AG_port
fapwwn --show -ag all
You should see output similar to the following sample. (In this example, long lines of output are
shown split across two lines, for better readability.)
-----------------------------------------------------------
AG Port
-----------------------------------------------------------
10:00:00:05:1e:65:8a:d5/16
10:00:00:05:1e:d7:3d:dc/8
Figure
50.
NPIV
N-Port
F-Port
for an HBA device connected
Port
Device Port WWN
--
--:--:--:--:--:--:--:--
20
20:08:00:05:1e:d7:2b:74
Configuring FA-PWWNs
Edge Switch
running FOS 7.0.0
F-Port
HBA
Scenario 2
Configure an FA-PWWN
directly to an edge switch.
\
\
\
\
16
331