Deleting A Member From The Acl - HP SN3000B Administrator's Manual

6. After verifying that the WWN was added correctly, enter 0 at the prompt to end the session.
7.
8. Press Enter to update the nonvolatile memory and end the session.
Example of adding a member to the management server ACL

Deleting a member from the ACL

When you delete a member from the ACL, that member no longer has access to the management
server.
Note that if you delete the last member of the ACL, so that the ACL list is empty, then the
management server is accessible to all systems connected in-band to the fabric.
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the msConfigure command.
3. At the "select" prompt, enter 3 to delete a member based on its port/node WWN.
Fabric OS Administrator's Guide
53-1002446-01
At the "Update the FLASH?" prompt, enter y.
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 2
Port/Node WWN (in hex): [00:00:00:00:00:00:00:00] 20:00:00:20:37:65:ce:aa
*WWN is successfully added to the MS ACL.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [2] 1
MS Access List consists of (14): {
20:00:00:20:37:65:ce:aa
20:00:00:20:37:65:ce:bb
20:00:00:20:37:65:ce:ff
20:00:00:20:37:65:ce:11
20:00:00:20:37:65:ce:22
20:00:00:20:37:65:ce:33
20:00:00:20:37:65:ce:44
10:00:00:60:69:04:11:24
10:00:00:60:69:04:11:23
21:00:00:e0:8b:04:70:3b
10:00:00:60:69:04:11:33
20:00:00:20:37:65:ce:55
20:00:00:20:37:65:ce:66
00:00:00:00:00:00:00:00
}
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 0
done ...
Update the FLASH? (yes, y, no, n): [yes] y
*Successfully saved the MS ACL to the flash.
The command becomes interactive.
Management server database
1
7