License Requirements For Fc-Fc Routing; Supported Platforms For Fc-Fc Routing - HP SN3000B Administrator's Manual
Brocade fabric os administrator's guide - supporting fabric os v7.0.1 (53-1002446-01, march 2012)
Hide thumbs
Also See for SN3000B:
- Troubleshooting manual (138 pages) ,
- Reference manual (70 pages) ,
- Quickspecs (21 pages)
Table of Contents
Advertisement
24
FC-FC routing overview
For more information about M-EOS connectivity, refer to
and M-EOS Fabrics Using FC
A Fibre Channel router (FC router) is a switch running the FC-FC routing service. The FC-FC routing
service can be simultaneously used as an FC router and as a SAN extension over wide area
networks (WANs) using FCIP.
You can set up QoS traffic prioritization over FC routers. Refer to
on page 419 for information about QoS and instructions for setting traffic prioritization over an FC
router.
License requirements for FC-FC routing
The Integrated Routing license is required for FC-FC routing between Fabric OS fabrics and between
Fabric OS and M-EOS fabrics.
NOTE
The Integrated Routing license is not required for connectivity between Fabric OS and Brocade
Network OS fabrics or between Brocade Network OS fabrics connected by an FC router.
The Integrated Routing license allows 8-Gbps and 16-Gbps FC ports to be configured as EX_Ports
(or VEX_Ports) supporting FC-FC routing.
Enabling the Integrated Routing license and capability does not require a switch reboot.
NOTE
Brocade recommends that all FC routers in a backbone fabric either have the Integrated Routing
license or not. It is not recommended to mix licensed and unlicensed FC routers in the backbone
fabric.
Supported platforms for FC-FC routing
FC-FC routing is supported on the following platforms:
•
•
•
•
•
•
•
For the Brocade Backbone families, note the following restrictions:
•
466
Router".
Brocade DCX and DCX 8510 Backbone families:
-
8-Gbps port blades (FC8-16, FC8-32, FC8-32E, FC8-48, FC8-48E, FC8-64)
-
16-Gbps port blades (FC16-32, FC16-48)
-
FX8-24 DCX Extension Blade
-
FR4-18i Router Blade (Brocade DCX Backbone family only, and only VEX_Ports)
Brocade 5100 switch
Brocade 5300 switch
Brocade 6510 switch
Brocade VA-40FC switch
Brocade 7800 Extension Switch
Brocade Encryption Switch
EX_Ports and VEX_Ports are supported only on the FX8-24 DCX Extension Blade, and the
8-Gbps and 16-Gbps port blades. Ports on the core blade cannot be configured as EX_Ports.
Appendix A, "Interoperation of Fabric OS
"QoS: SID/DID traffic prioritization"
Fabric OS Administrator's Guide
53-1002446-01
Advertisement
Table of Contents
