Disabling Virtual Fabrics Mode - HP SN3000B Administrator's Manual

10

Disabling Virtual Fabrics mode

3. Delete all Admin Domains, as described in
4. Enter the following command to enable VF mode:
5. Enter y at the prompt.
Example
The following example checks whether VF mode is enabled or disabled and then enables it.

Disabling Virtual Fabrics mode

When you disable VF mode, the following occurs:
•
•
If you want to use Admin Domains in a fabric, you must first disable VF mode.
1. Connect to the physical chassis and log in using an account with the chassis-role permission.
2. Enter the following command to check whether VF mode is disabled:
3. Move all ports to the default logical switch.
4. Delete all of the non-default logical switches.
5. Enter the following command to disable VF mode:
6. Enter y at the prompt.
226
non-disruptively" on page 354.
fosconfig --enable vf
switch:admin> fosconfig --show
FC Routing service:
iSCSI service:
iSNS client service:
Virtual Fabric:
Ethernet Switch Service:
switch:admin> fosconfig --enable vf
WARNING: This is a disruptive operation that requires a reboot to take
effect.
All EX ports will be disabled upon reboot.
Would you like to continue [Y/N] y
VF has been enabled. Your system is being rebooted.
The CPs are rebooted.
If F_Port trunking is enabled on ports in the default switch, the F_Port trunking information is
deleted.
fosconfig --show
lscfg --config 128 -slot slot -port port
lscfg --delete fabricID
fosconfig --disable vf
"Deleting all user-defined Admin Domains
disabled
Service not supported on this Platform
Service not supported on this Platform
disabled
Service not supported on this Platform
Fabric OS Administrator's Guide
53-1002446-01