Troubleshooting Ti Zone Routing Problems - HP SN3000B Administrator's Manual

1. Connect to the switch and log in using an account with admin permissions.
2. Enter the zone

Troubleshooting TI zone routing problems

Use the following procedure to generate a report of existing and potential problems with TI zones.
The report displays an error type.
•
•
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the zone
Fabric OS Administrator's Guide
53-1002446-01
show command.
--
zone --show [ name ] [-ascending]
To display information about the TI zone purplezone:
switch:admin> zone --show purplezone
Defined TI zone configuration:
TI Zone Name: redzone:
Port List: 1,2; 1,3; 3,3; 4,5
Configured Status: Activated / Failover-Enabled
Enabled Status: Activated / Failover-Enabled
To display information about all TI zones in the defined configuration in ascending order:
switch:admin> zone --show -ascending
Defined TI zone configuration:
TI Zone Name: bluezone:
Port List: 8,3; 8,5; 9,2; 9,3;
Configured Status: Deactivated / Failover-Disabled
Enabled Status: Activated / Failover-Enabled
TI Zone Name: greenzone:
Port List: 2,2; 3,3; 4,11; 5,3;
Configured Status: Activated / Failover-Enabled
Enabled Status: Activated / Failover-Enabled
TI Zone Name: purplezone:
Port List: 1,2; 1,3; 3,3; 4,5;
Configured Status: Activated / Failover-Enabled
Enabled Status: Deactivated / Failover-Enabled
"ERROR" indicates a problem currently exists in the fabric.
"WARNING" indicates that there is not currently a problem, given the current set of online
devices and reachable domains, but given the activated TI zone configuration, parallel
exclusive paths between a shared device and a remote domain have been detected, which
might cause a problem for devices that join the fabric later.
showTIerrors command.
--
zone --showTIerrors

Troubleshooting TI zone routing problems

12
291