Supported Configurations For Fc-Fc Routing; Unsupported Configurations For Network Os Connectivity - HP SN3000B Administrator's Manual

Brocade fabric os administrator's guide - supporting fabric os v7.0.1 (53-1002446-01, march 2012)
Hide thumbs Also See for SN3000B:
Table of Contents

Advertisement

Refer to the Network OS Administrator's Guide for supported Network OS platforms.

Supported configurations for FC-FC routing

FC-FC routing supports the following configurations:
In configurations with two backbone fabrics connected to the same edge fabric, routing is not
supported between edge fabrics that are not directly attached to the same backbone fabric.
Routing over multiple backbone fabrics is a multi-hop topology and is not allowed.
In an edge fabric that contains a mix of administrative domain (AD)-capable switches and switches
that are not aware of AD, the FC router must be connected directly to an AD-capable switch. For
more information, refer to
page 485.
VEX edge to VEX edge device sharing is not supported.

Unsupported configurations for Network OS connectivity

Note the following configuration limitations for Network OS connectivity:
Fabric OS Administrator's Guide
53-1002446-01
VEX_Ports are supported on the FR4-18i Router Blade, but EX_Ports are not supported. The
FR4-18i blade is not supported in the same chassis as the FX8-24 blade.
The Backbones have a limit of 128 EX_Ports for each chassis.
FC router connected to a Fabric OS nonsecured edge fabric.
FC router connected to a Fabric OS secured edge fabric.
FC router connected to a Brocade Network OS edge fabric (Network OS v2.1.1 or later).
FC router connected to an M-EOS Open Mode edge fabric.
FC router connected to an M-EOS Fabric Mode edge fabric.
FC router interoperating with legacy FC routers (Brocade 7500 switch or FR4-18i blade).
"Use of Admin Domains with LSAN zones and FC-FC routing"
All of the platforms listed in
FC-FC routing to a Brocade Network OS fabric, except for the following:
-
Brocade Encryption Switch
-
FR4-18i Router Blade
VEX_Ports do not support Network OS connectivity.
FCoE devices connected to a Brocade 8000 switch or FCOE10-24 blade cannot communicate
with FCoE devices in the Network OS fabric.
If Admin Domains are enabled, connectivity between the Fabric OS fabric and a Brocade
Network OS fabric is not supported.
Connectivity between a Brocade Network OS fabric and an M-EOS fabric is not supported.
"Supported platforms for FC-FC routing"
FC-FC routing overview
on
on page 466 support
24
467

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fabric os v7.0.1

Table of Contents