Creating A Ti Zone In A Base Fabric - HP SN3000B Administrator's Manual

To create TI zones in a logical fabric, such as the one shown in
Remember that your changes are not enforced until you enter the cfgEnable command, as shown
here:

Creating a TI zone in a base fabric

1. Connect to the switch and log in using an account with admin permissions.
2. Create a "dummy" zone configuration in the base fabric. For example:
3. Enter the zone
4. Perform the following steps if you have any TI zones with failover disabled. If all of your TI zones
5. Enter the cfgEnable command to reactivate your current effective configuration and enforce
Fabric OS Administrator's Guide
53-1002446-01
Log in to the logical switch FID1, Domain 7 and create a TI zone in the logical fabric with FID=1:
LS1> zone --create -t ti -o f "ti_zone1" -p "8,8; 8,1; 3,3; 3,10; 5,16; 5,8;
9,5; 9,9"
Then create a TI zone in the base fabric, as described in
switch:admin> cfgenable "USA_cfg"
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
If the update includes changes to one or more traffic isolation zones, the
update may result in localized disruption to traffic on ports associated with
the traffic isolation zone changes
Do you want to enable 'USA_cfg' configuration (yes, y, no, n): [no] y
zone config "USA_cfg" is in effect
Updating flash ...
zone --create "z1", "1,1"
cfgcreate "base_config", z1
create command to create the TI zone in the base fabric:
--
zone --create -t objtype -o f name -p "portlist"
The disable failover option is not supported in base fabrics.
are failover-enabled, skip to
a. Change the failover option to failover enabled. This is a temporary change to avoid frame
loss during the transition.
zone --add -o f name
b. Enable the zones.
cfgenable "current_effective_configuration"
c. Reset the failover option to failover disabled. Then continue with
zone --add -o n name
the TI zones.
cfgenable "base_config"
step 5.
Creating a TI zone
Figure 43 on page 283:
"Creating a TI zone in a base
step 4.
12
fabric".
287