Replacing The Pci Card Cage; Removing And Replacing Pci Cards; Figure 6-55 Removing The Pci Card Cage Cover - HP 9000 rp3410 User's & Service Manual

Removing and Replacing Components

Removing and Replacing PCI Cards

Step 4. Grasp the PCI card cage cover and slide it away from the bulkhead end of the cage, then lift the
cover off.

Figure 6-55 Removing the PCI Card Cage Cover

Step 5. The PCI cards are now accessible for removal and replacement.
Step 6. Unscrew the bulkhead screw that holds the PCI card in place.

Replacing the PCI Card Cage

To replace the PCI card cage into the server, follow these steps:
Step 1. Hold the cover in mounting position and slide it toward the bulkhead end of the cage.
Step 2. Hold the PCI card cage above the chassis mounting position, such that the bulkhead end of the cage
is toward the server rear panel. (See Figure 6-54.)
Step 3. Hold the PCI card cage release lever in the raised position and lower the PCI card cage into the
server chassis.
Step 4. Press the PCI card cage release lever into the lowered position to lock the PCI card cage into the
server chassis.
Step 5. Reconnect the cables to the PCI card.

Removing and Replacing PCI Cards

The server can contain up to four PCI cards. PCI cards are located in the PCI card cage.
The HP 9000 rp3410 provides two 64-bit, 133 MHz PCI-X card sockets and the HP 9000 rp3440 server
provides four 64-bit, 133 MHz PCI-X card sockets.
202
Chapter 6