Remove The Front Bezel; Removing A Locked Front Bezel - HP Enterprise ProLiant MicroServer Gen10 User Manual

For more information, see the lock documentation.
2. Connect all peripheral cables to the server.
3. Connect the power cord to the server power jack, and then to the AC source.
4. Secure the power cord and rear panel cables based on the standard cable management practices.
5. Power up the server.

Remove the front bezel

To access the drive bays, remove the front bezel.

Removing a locked front bezel

Prerequisites
1. Power down the server.
2. Disconnect the power cord from the AC source, and then from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the chassis cover.
Procedure
1. To unlock the front bezel from the chassis, slide the release tab upward.
2. Open the front bezel.
The front bezel is a removable part. Opening the bezel will loosen it from the front panel.
3. To completely detach the bezel from the front panel, pull the bezel hinges from the chassis.
Retain the bezel for later use.
27
Operations