Installing The Rear Adapter Retention Bracket; Removing The Front Adapter-Retention Bracket - Lenovo ThinkServer TS100 Hardware Maintenance Manual

6. If necessary, remove the Remote Supervisor Adapter II SlimLine retention tab

Installing the rear adapter retention bracket

To install the rear adapter-retention bracket, complete the following steps:
1. If you removed the Remote Supervisor Adapter II SlimLine retention tab earlier,
2. Position the rear adapter retention bracket so that the hole in one of the hinge
3. Rotate the rear adapter-retention bracket into place so that the hole in the
4. Install the side cover (see "Installing the side cover" on page 63).
5. Lock the side cover if you unlocked it during removal.
6. Reconnect the external cables and power cords; then, turn on the attached

Removing the front adapter-retention bracket

To remove the front adapter-retention bracket, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the side cover" on page 62).
4. Open the front and rear adapter-retention brackets.
5. Remove all adapters (if necessary) and place them on a static-protective
6. Grasp one side of the bracket at a hinge point and pull outward (while you
102
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual
Hinge pin
Rear adapter
retention
bracket
and store it for future use.
reinstall it on the rear adapter-retention bracket and any other adapters that you
might have removed.
points is aligned with the hinge pin on the chassis; then, place the hinge pin
through the hole on the chassis.
opposite hinge point snaps into place over the hinge pin on the chassis.
devices and turn on the server.
on page 57.
and external cables.
surface.
Note: You might find it helpful to note where each adapter is installed before
you remove the adapters.
rotate the bracket slightly toward the rear of the server) until the hinge pin on
the bracket is free of the hole; then, grasp the bracket on the other side at the
hinge point, pull outward until the bracket is free of the hinge pin, and remove
the rear adapter-retention bracket from the server.