Installing The Rear Adapter Retention Bracket - Lenovo ThinkServer TD100 Hardware Maintenance Manual

6. If necessary, remove the Remote Supervisor Adapter II SlimLine retention tab

Installing the rear adapter retention bracket

To install the rear adapter retention bracket, complete the following steps:
1. If you remove the Remote Supervisor Adapter II SlimLine retention tab earlier,
2. Position the rear adapter retention bracket so that the hole in one of the hinge
3. Rotate the adapter guide into place so that the hole in the opposite hinge point
4. Install the side cover (see "Installing the side cover" on page 79).
5. Lock the side cover if it was unlocked during removal.
6. Reconnect the external cables and power cords; then, turn on the attached
112
ThinkServer TD100 and TD100x: Hardware Maintenance Manual
and store it for future use.
reinstall it and any other adapters you might have removed.
points is aligned with the hinge pin on the chassis; then, place the hinge pin
through the hole on the chassis.
snaps into place over the hinge pin on the chassis.
devices and turn on the server.