Delta BLD-E1 Series User Manual page 97

Chapter 4 ParametersAT |Troubleshooting}| BLD-E1 Series
Settings Functions
Over-current Stall
22
Prevention Warning
Over-voltage Stall
23
prevention Warning
Operation Mode
24
Indication
25 Forward Command
26 Reverse Command
27~30 Reserved
31 Forward running input
Reverse running input
32
Zero Speed (actual
33
output frequency)
Zero Speed with Stop
34
(actual output frequency)
35~39 Reserved
Speed Attained
40
(including zero speed)
Reserved
02-15
Reserved
02-16
Reserved
02-17
Reserved
02-18
Reserved
02-19
Reserved
02-20
Reserved
02-21
Reserved
02-22
Multi-output Direction
02-23
Control
VF VFPG
mode
Settings
This parameter is bit setting. If the bit is 1, the multi-function output terminal will be act with
opposite direction. For example, if Pr.02-13 is set to 1 and forward bit is 0, Relay 1 will be ON
4-56
Active when the over-current stall prevention is detected.
Active when the over-voltage stall prevention is detected.
Active when the operation command is controlled by external
terminal. (Pr.00-15 = 1) and PU LED on keypad KPVL-CC01 is
OFF.
Active when the operation direction is forward.
Active when the operation direction is reverse.
Motor forward run (FWD).
Motor Reverse run (REV).
Active when the actual output frequency is 0. (the drive should
be at RUN mode)
Active when the actual output frequency is 0 or Stop. (the
drive should be at RUN mode)
Active when the output frequency reaches frequency setting.
FOCPM
0 ~ 65535
Descriptions
Factory setting: 0
Revision May 2009, 00DE, V0.50