Table of Contents
Advertisement
Chapter 4 ParametersAT |Troubleshooting}| BLD-E1 Series
33: Low torque bias (by Pr.07-23)
34-37: Reserved
38: Disable EEPROM write function
39：Reserved
40：Enable drive to function
This parameter selects the functions for each multi-function terminal.
If Pr.02-00 is set to 3-wire operation control. Terminal MI1 is for STOP terminal. Therefore,
MI1 is not allowed for any other operation.
Settings
0
No Function
Multi-step speed
1
command 1
Multi-step speed
2
command 2
Multi-step speed
3
command 3
Multi-step speed
4
command 4
5
Reset
6
Reserved
Acceleration/deceleration
7
Speed Inhibit
4-50
Settings
Functions
15 step speeds could be conducted through the digital
statuses of the 4 terminals, and 17 in total if the master
speed and JOG are included. (Refer to Pr. 04-00~04-15)
After the error of the drive is eliminated, use this
terminal to reset the drive.
When this function is enabled, acceleration and
deceleration is stopped and the brushless DC motor
drive starts to accel./decel. from the inhibit point.
VF
○
○
○
Descriptions
When using communication to control the multi-step
speed, setting 1 to 4 will be invalid.
VFPG
FOCPM
○
○
○
○
○
○
Revision May 2009, 00DE, V0.50
Advertisement
Table of Contents
