Delta BLD-E1 Series User Manual page 83

Chapter 4 ParametersAT |Troubleshooting}| BLD-E1 Series
Group 01 Basic Parameters
Maximum Output Frequency
01-00
Control
VF VFPG
mode
Settings
This parameter determines the brushless DC motor drive's Maximum Output Frequency. All
the brushless DC motor drive frequency command sources (analog frequency inputs 0 to
+10V and 4 to 20mA) are scaled to correspond to the output frequency range.
1st Output Frequency Setting
01-01
Control
VF VFPG
mode
Settings
It is for the base frequency and motor rated frequency.
This value should be set according to the rated frequency of the motor as indicated on the
motor nameplate. If the motor is 60Hz, the setting should be 60Hz. If the motor is 50Hz, it
should be set to 50Hz.
1st Output Voltage Setting
01-02
Control
VF VFPG
mode
Settings 230V series 0.1 to 255.0V
460V series 0.1 to 510.0V
It is for the base frequency and motor rated frequency.
This value should be set according to the rated voltage of the motor as indicated on the motor
nameplate. If the motor is 220V, the setting should be 220.0. If the motor is 200V, it should be
set to 200.0.
There are many motor types in the market and the power system for each country is also
difference. The economic and convenience method to solve this problem is to install the
brushless DC motor drive. There is no problem to use with the different voltage and frequency
and also can amplify the original characteristic and life of the motor.
4-42
FOCPM
120~4000rpm (10~400z)
FOCPM
0.00~400.00Hz
FOCPM
This parameter can be set during operation.
Factory setting: 3000(250)
Revision May 2009, 00DE, V0.50
Factory setting: 60.00
Factory Setting: 220.0
Factory Setting: 440.0