Epson Stylus Pro 5000 Service Manual page 98

Stylus Pro5000
7. From right side of the printer mechanism, remove one "E" shaped ring
securing "Axis, CR, Support".
8. Rotate a bush for fixing an axis(shaft) toward right direction and remove
the bush. (Refer to Figure4-43)
9. Remove "Axis, CR, Support" from the mechanism.
CHECK POINT
When re-installing "Axis, CR", set a leaf
spring(8.2x0.15x15) to the axis first, then, install a
plain washer(8.2x0.15x15). Also, when installing a
leaf spring, convex side should face to inside.
(Refer to Figure4-44)
Rev. B
Chapter4 Assembly and Disassembly
Fixing bush for "Axis, CR, Support"
Figure 4-43. Removing a fixing bush for Axis, CR Support
Plain Washer
(8.2x0.15x15)
Leaf Spring(8.2x0.15x15)
Figure 4-44. Axis, CR, Support Removal
"E" shaped ring
"Axis, CR, Support"
4-24