Epson Stylus Pro 5000 Service Manual page 134

Stylus Pro5000
StepC. If you find any failures on any checking procedures written
above, remove each "E" shaped ring, which is securing gear,
and arrange alignment until they become just like as it is
shown in Figure4-113, then fix them by "E" shaped ring.
(Refer to next section for more details)
CHECK POINT
When installing "ASF Unit", if your condition is
quite different from the condition shown in
Figure4-113, or if you rotate "Combination
Gear,24,24" to left direction and gear(s) get locked
and stops rotation, refer to following procedure.
Also, if it is necessary to disassemble or assemble
"ASF Unit" because of damaged parts in the "ASF
Unit" or separated parts by dropping, refer to
section 4.4 "Disassembly and Assembly for ASF
Unit".
Step.A Remove "E" shaped rings on the "Gear,24", "Combination
Gear,24,24" and "Gear,11", then, remove "Gear,24",
"Combination gear,24,24", "Gear,11" and "Gear,10" from
"ASF Unit".
Step.B Insert a positioning pin for alignment into "Curl Unit" and fix it.
(It is recommended to fix the second "Curl Unit" from left)
(Refer to Figure4-114)
CHECK POINT
If you want to match the hole on the metal frame
of "Curl Unit" and hole on the plastic part, those
holes can be easily matched by rotating a small
axis for "Gear,10". (Refer to Figure4-113)
Step.C Insert "Gear,24", and fix it with "E" shaped ring.
(Refer to Figure4-113)
Step.D Rotate "Gear,24"and insert the pin into the positioning
hole(for alignment).
Step.E Set "Gear,11". (Refer to Figure4-113)
Step.F Set "Gear,10", and fix it with "E" shaped ring.
(Refer to Figure4-113)
Rev. B
Chapter4 Assembly and Disassembly
"Combination Gear,24,24"
"Gear,11"
"Gear,10"
"Positioning Pin for Phase"
Figure 4-113. Adjusting Alignment for ASF Unit
Second "Curl Unit" from left
Figure 4-114. Setting "Curl Unit"
"Gear,24"
Positioning Pin
4-60